The workpiece prone to deformation should be placed in the middle of the whole carbon steel plate A36 prices steel plate as far as possible, and the distance between the workpiece should be enough. Choose a reasonable cutting sequence, the location of the perforation points should be correct, so as to avoid the deformation of the cutting parts.
What should be paid attention to when using carbon steel plate A36 prices, carbon steel? First, the strength level of carbon steel is low and it is easy to fracture, so carbon steel is not suitable for high strength engineering. Second, the heat-resistant performance of carbon steel is relatively poor, which can not be applied in the long-term high-temperature fields such as boilers. Third, the carbon steel is extremely easy to rust, so it is not suitable for water transport projects. Therefore, the use of carbon steel depends on the use of the environment, if it is harsh conditions, it is better to choose other steel materials.
The steel such as carbon steel plate A36 prices delivered in the hot-rolled state has a certain degree of corrosion resistance due to the high temperature, so it can be stored in the open air. However, this layer of oxide scale also makes the hot-rolled steel surface rough and the size fluctuates greatly. Therefore, the steel with smooth surface, accurate size and good mechanical properties is required to be produced by using hot-rolled semi-finished products or finished products as raw materials and then cold rolling.
In the operation process of carbon steel plate A36 prices steel plate cutting, when automatic cutting is carried out, the distance difference between the hanging steel plate and the gas cutting platform should be adjusted to within 5mm between the two ends of the steel plate and the guide rail.
