BEBON Iron & Steel has fully passed the ISO9001 quality system certification, marine steel has passed 9 countries' classification societies, and construction steel has obtained the CE Lloyd's CE Mark certification. The main body of A283 Gr D CS steel carbon plate steel passed ISO14001 environmental management system certification and OHSAS18001 occupational health and safety management system certification. The main A283 Gr D CS steel carbon plate production processes and technical equipment of the enterprise have reached the international advanced level, the comprehensive competitiveness has entered the international advanced ranks, and the international influence has been significantly enhanced.
Many people will mix strip steel and steel plate together, which can usually be distinguished from the following points. First of all, the thickness of the steel plate is much thicker, and the thinner the strip steel is required, the better. Secondly, in appearance, the steel strip can be crimped and the steel plate is too thick to bend, even if it is bent, it is difficult to recover, because it is easy to break if it is bent too much. Thirdly, the strength of A283 Gr D CS steel carbon plate, steel plate is higher than that of strip steel. The steel plate is suitable for construction engineering, while strip steel is only suitable for processing into hardware products.
Ordinary medium and thick steel plate A283 Gr D CS steel carbon plate is a kind of deoxidized steel. The oxygen content of the steel liquid is relatively high, and a lot of gas will be produced during the production process to make the steel liquid boil, so it is also called boiling steel. Advantages: this kind of steel plate has smooth surface, good quality and easy processing. Because this kind of steel plate has no concentrated shrinkage cavity, the amount of deoxidizer is very small and the price is lower than other steel plates.
Normalizing is to heat the steel parts to 30~80℃above the critical temperature for a period of time. Then the parts are taken out of the furnace and cooled in air. Since the cooling rate of normalizing is faster than that of annealing, the strength and hardness of normalized A283 Gr D CS steel carbon plate are higher than that of annealed A283 Gr D CS steel carbon plate, but the elimination of internal stress is not as good as annealing. The normalizing operation of A283 Gr D CS steel carbon plate is simple, the cost is low, the productivity is high, and it is widely used in actual production.
Chemical composition differences between the A283 Gr D CS steel carbon plate, Q345 steel grades (Q345A / Q345B / Q345C / Q345D / Q345E):Q345A steel：C≤0.20，Mn ≤1.70，Si≤0.50，P≤0.035，S≤0.035； Q345B steel：C≤0.20，Mn ≤1.70，Si≤0.50，P≤0.035，S≤0.035； Q345C steel：C≤0.20，Mn ≤1.70，Si≤0.50，P≤0.030，S≤0.030，Al≥0.015； Q345D steel：C≤0.18，Mn ≤1.70，Si≤0.50，P≤0.030，S≤0.025，Al≥0.015； Q345E steel：C≤0.18，Mn ≤1.70，Si≤0.50，P≤0.025，S≤0.020，Al≥0.015； All the Q345 steel grades contain Nb≤0.07，V≤0.15，Ti≤0.20，Cr≤0.30，Ni≤0.012，Mo≤0.10。
We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.
