Standing at a new historical starting point, we adapt to the requirements of supply side structural reform, adhere to the overall strategy of "innovation driven, quality leading, A573 Gr 70 plate quality improving and efficiency increasing, transformation and development", and constantly improve the development concept and development level with a forward-looking vision and grand vision. Now we have been ranked the A573 Gr 70 plate International leading steel materials supplier.
EN10025-2 S235J2 steel is equivalent to our Chinese teel grade Q235D. They are both done low temperature impact test at -20℃. Sometimes S235J2 would be used to built containers which can bear low temperature sea water. A573 Gr 70 plate, S235J2+N steel plate, following a rolling process within a certain temperature range, producing a material in a condition equivalent to that obtained after normalization. With the result that the specified mechanical properties values are conserved even after normalization treatment.
20G steel is a common carbon steel used to manufacture boilers. The performance of 20G steel is basically the same as that of 20# steel. The requirements for impact toughness, strain aging impact value and cold bending of 20G steel are increased. The yield ratio of 20G steel is slightly higher, and certain fatigue and corrosion resistance are required for A573 Gr 70 plate steel to ensure the safe operation of boilers. 20G steel is suitable for manufacturing marine boilers, steam boilers and other boiler accessories with pressure less than 6Mpa and wall temperature less than 450 ℃.
We do sand blasting and shop primer for various A573 Gr 70 plate steel plates such as carbon steel plates, high strength low alloy steel plates, shipbuilding steel plates, etc. before delivery, so as to protect the steel plates from going rust during transportation. Our sand blasting standard is SA2.5, and shop primer A573 Gr 70 plate thickness is 20μm or so. Our shop primer has been certified by ABS, LR, BV etc. authorities.
Mechanical properties of 45# steel high-quality carbon structural steel: Tensile strength σb (MPa): ≥600, yield strength σs (MPa): ≥355, elongation δ5 (%): ≥16, section shrinkage ψ (%): ≥40, impact energy Akv (J): ≥39. 45# steel impact toughness value αkv (J / cm2): ≥49 (5), hardness: unheated, ≤229HB; annealed steel, ≤197HB. A573 Gr 70 plate, 45# steel chemical composition % (Carbon: 0.42 to 0.50, Silicon: ≤0.40, Manganese: 0.50 to 0.80, Sulfur: ≤0.045, Phosphorus: ≤0.045, Chromium: ≤0.40, Nickel: ≤0.40, Molybdenum: ≤0.10).
Our quality and service commitment: A573 Gr 70 plate product quality problems, life-long replacement.In the process of using, any time if you find we supplied steel materials not conform to the requirements of technical standards, we can replace it for you free of charge. However, it should be noted that non product quality problems caused by improper use are not covered by the warranty. Please pay attention to the service time commitment as well as the product quality assurance commitment. Because only the products of big brands and reliable enterprises with complete after-sales service system can truly realize the long-term product quality assurance and the whole process of service.
