Available steel plate types: A514 grade P structural steel material, carbon structural steel plate, low alloy high strength steel plate, bridge steel plate, building structural steel plate, shipbuilding and offshore platform steel plate, boiler and pressure vessel steel plate, mold steel plate, alloy structural steel plate, oil and gas transmission pipeline steel plate, high strength and high toughness steel plate, corrosion-resistant steel plate, composite steel plate, wear-resistant steel plate, etc.
A514 grade P structural steel material, St52-3 steel is a low alloy, high strength structural steel which can be readily welded to other weldable steel. St52-3 steel's mechanical properties is yield strength more than 355 MPa, tensile strength 490-630Mpa. For St52-3 steel, the C element content is 0.24%, the Si element content is 0.55% max, the Mn element content is 1.60% max, the P element content is 0.045% max, the S element content is 0.045% max.
How to distinguish the inferior steel plate? 1. The surface of the fake and inferior steel plate is easy to produce scab. 2. The material of fake and inferior steel plate is not uniform and there are many impurities. The surface of fake and inferior steel plate is often pitted. Pitting is an irregular and uneven defect on the surface of A514 grade P structural steel material, steel plate caused by serious wear of rolling groove. Due to the pursuit of profit by the manufacturers of fake and inferior steel plates, the groove rolling often exceeds the standard.
At present, there are many cutting methods for A514 grade P structural steel material steel plate cutting, such as common flame cutting, plasma cutting and laser cutting. Different cutting methods correspond to different cutting tools and cutting equipment. Therefore, based on this point, we can know that the answer to this question is yes, that is, there are many tools and equipment involved in A514 grade P structural steel material steel plate cutting, You can choose according to the cutting mode.
