The advantages of A514 Gr Q alloy steel plate, seamless steel pipe are high pressure resistance, good toughness, long pipe section and few joints. It is widely used and the rolling technology of domestic steel mills is also very mature. Compared with round steel, the weight of seamless steel pipe is lighter under the same strength. Seamless steel pipe manufacturing ring parts, can improve the utilization of materials, simplify the manufacturing process, save materials and processing time. Compared with the welded pipe, there is no weld on the outer surface of seamless steel pipe, and it has good compression resistance.
Hot Rolled Plates A514 Gr Q alloy steel plate MachiningAfter final forging/forming and Heat treatment process, all the pipe Fittings, Flanges, Fasteners, Etc. are sent for machining i.e. and preparation, O/D and I/D matching as per dimensional codes. An Expert Q.C. engineer is involved and he keeps constant vigil on every machining operation. Step machining is carried out as required by the codes. GO and NO-GO gauges are used to check the O/D & I/D of the fittings, Flanges, etc.
S355J2 steel plate A514 Gr Q alloy steel plate rolling process is controlled rolling process. In the rolling process, the ingot rolling temperature is 1000-1050℃; in the first stage, the low-speed and large reduction rolling process is adopted, the high-temperature stage is 950-1000℃, the rolling speed is 1.6-2.0m/s, the A514 Gr Q alloy steel plate single reduction rate is 15-20%, and the cumulative reduction rate is 40-45%, so as to ensure sufficient deformation of ingot. In the first stage, the start rolling temperature is 910-930℃, and the finish rolling temperature is ≤ 870℃.
The blanking of the structural steel plate is first to find 90 degrees, and then use a tape measure and a powder line to draw the cutting range. According to the thickness of the carbon steel plate plus the cutting allowance, drilling is required. For the deep processing of A514 Gr Q alloy steel plate structural steel sections or profiles: First use a square ruler or a curved ruler to find 90 degrees, and then use a square ruler or a ruler to cut the line and add the cutting margin to the hole.
