The difference between Q235 steel and Q345 steel:The lower limit of yield strength of Q235 steel is 235MPa, the lower limit of yield strength of Q345 steel is 345MPa. The ASTM A573 carbon steel plate alloy content of Q235 steel is common carbon steel and Q345 steel is low alloy steel. Q345 steel is used for structures, mechanical parts, building structures, general metal structures bearing dynamic loads such as medium and low pressure vessels, oil tanks, vehicles, cranes, ASTM A573 carbon steel plate mining machinery, power stations, bridges, etc..
The company now has ASTM A573 carbon steel plate oversea market department, sales and supply department, finance department, logistics department, technical equipment department, quality management department, production department and other departments. The staff with college degree or above accounted for more than 80%, and there were more than ASTM A573 carbon steel plate 30 professional and technical personnel. The LSAW pipe production line can produce welded pipes with Φ350-1800mm, wall thickness 6-80mm, and length 2-12m.
Semi-endless rolling technology has three advantages: the ASTM A573 carbon steel plate product's limit thickness and limit width specification range has been significantly expanded. The thinnest thickness of SPHC steel has been expanded from 1.0 mm to 0.78 mm, and the limit specification product width has been expanded from 1100 mm to 1300 mm; The thinnest thickness of Q235B steel has been expanded from 1.2 mm to 1.0 mm, and the width range of the limit specification products has also been further expanded.
ASTM A573 carbon steel plate, Special thick steel plate cutting needs to be preheated in advance. Some steel plates are prone to cracks after entering the cutting process, sometimes that is because the temperature is too low, and it is necessary to perform pre-heat treatment in advance for such cases. The staff can preheat the steel plates first, so that the temperature of the steel plates will gradually increase, and then the flame gun can be used to cut. The probability of cracks in the cut material is very low, and the quality of the steel plate is also guaranteed.
We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.
