Our company attaches great importance to technical support and after-sales service, and has established a customer service center to provide unified technical support and service for A514 grade E high strength steel plate various engineering projects. Customer service center has a strong technical force of technical service team, composed of a customer service center manager, several A514 grade E high strength steel plate after-sales service personnel, responsible for unified acceptance and processing of local after-sales service needs.
Boiler steel refers to the special steel used to manufacture pressure components of steam boilers, such as steam drums. The boiler steel mainly means boiler steel plates and seamless boiler steel pipes. Boiler components not only bear pressure loads but are also heated by direct fire, so the requirements on the chemical composition and mechanical properties of boiler steel, A514 grade E high strength steel plate are strict. In the chemical composition of boiler steel, A514 grade E high strength steel plate, sulfur and phosphorus are strictly controlled. Tensile strength, yield point, elongation, impact energy value and 180 ° cold bending are required to be tested in boiler steel mechanical properties. In addition, strain aging impact test is also required for boiler steel. The quality control of boiler steel is slightly higher than that of pressure vessel steel.
SA537 grade 70 steel with the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the A514 grade E high strength steel plate, SA537 grade 70 steel coil thickness should not exceed 25 mm. The mechanical properties of SA537 grade 70 steel is yield strength is 290MPa, and the tensile strength is 485-620Mpa.
We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.
